How to find us: 
Qualification Code: 603/2625/6
What is this qualification?
These awards between them cover the theory and practice involved with the initial verification and commissioning and periodic inspection, testing and condition reporting of both single and three phase electrical installations. The Level 3 Award in Electrical Installation Inspection, Testing, Certification and Reporting is a combined award and covers both initial verification and periodic inspection and testing. The awards follow BS 7671 and the industry recognised IET Guidance Note 3 and the Best Practice Guides from Electrical Safety First. The awards provide an opportunity for individuals to develop and/or enhance their knowledge and skills in the inspection and testing of single and three phase low voltage electrical installations.
Who is this qualification for?
- Those who wish to further their career in the electrotechnical sector
- Electricians who wish to carry out inspection, testing and commissioning; and periodic inspection, testing and condition reporting
- Those who wish to obtain an Industry recognised qualification.
What does this qualification cover?
The application of knowledge involved with the inspection and testing of electrical installations. Each Award has one unit which covers the necessary learning outcomes for initial verification, and periodic inspection and testing of electrical installations. This includes learning outcomes about safe isolation, inspection, safe testing, pre-energised and energised tests, documentation, and the practical use of test equipment. The structure of each of the qualifications is listed in Section 3. The examinations for these qualifications are open book. The on-screen exam allows the use of Guidance Note 3 Inspection & Testing Published by The Institution of Engineering and Technology.
Support for this Qualification
This Electrical Installation Inspection, Testing, Certification, and Reporting Course is:
- Regulated at Level 3
- Industry recognised
- Supported by Certsure
- Supported by the JIB.
Achievement of the Qualification
Each qualification is achieved when the unit assessments have been successfully completed. The Centre will then be able to apply for the learner’s certificate. Overall grading type: Pass /Fail.
WHAT YOU NEED TO BRING
Delegates will need to provide photographic identification as well as their National Insurance number on their first day of training. The following photographic identification is accepted:
- Passport
- Driving Licence etc.
ENTRY REQUIREMENTS
There are no formal entry requirements for these qualifications; however centres should ensure that the learners have the potential to achieve these qualifications. Learners must have the minimum levels of literacy and numeracy to complete the learning outcomes and assessments.
It is recommended that learners have completed a recognised electrical apprenticeship, or as a minimum hold qualifications covering inspection and testing, and a current qualification to the wiring regulations. The guided learning hours attributed to this qualification assume the average learner will be involved in the electrical contracting industry.
C&P Training Services will make learners with particular requirements aware of the content of the qualification and they will be given every opportunity to successfully complete the qualification. EAL will consider any reasonable suggestions for, and from, those with disabilities that would help them to achieve the learning outcomes without compromising the standards required.
Find out about our range of hazardous area CompEx Electrical Courses
C&P Training Services Ltd is part of the group of companies owned by C&P Group Holdings Ltd
Book This CourseEnquire about this course
If you're not ready to book a place but would like more information on this course, please use the form below.